$M$-半群的直觉$(S,T)$-模糊$M$-子半群的性质

K.T.Atanassov在1986年首先引入直觉模糊集的概念,本文利用s-范数和t-范数,引入M-半群的直觉(S,T)-模糊M-子半群的概念,刻画其性质和特征,我们再进一步给出了直觉(S,T)-直积的概念,并由此探讨了一些有意义的相关结论。     

锂锰尖晶石红外光谱的研究

本文对锂锰尖晶石的红外光谱进行了研究。由于锂锰尖晶石的晶体结构属于Fd3m空间群,锂离子占据四面体空隙(8a位置),锰离子占据八面体空隙(16d位置)。根据群论的知识,对锂锰尖晶石晶体中离子的振动方式与红外活性之间的内在关系进行了讨论。并列出了锂锰尖晶石的红外光谱实验数据。通过理论分析,我们推断:位于618.6和501.5cm~(-1)的红外吸收带分别来源于Mn(Ⅳ)-O和Mn(Ⅲ)-O键在晶体中的不对称伸缩振动(单元为Mn(Ⅳ)O_6和Mn(Ⅲ)O_6八面体),位于1124cm~(-1)的弱红外吸收带来源于Li-O键的不对称伸缩(单元为LiO_4四面体)。还有一些低于400cm~(-1)的可能吸收带在400～4000cm~(-1)范围内未能检测到。这一结论的可靠性通过锂锰尖晶石和掺杂的锂锰尖晶石的红外光谱实验数据得到证实。     

Foams and surface rheological properties of β-casein, gliadin and glycinin

Interfacial rheological properties and their suitability for foam production and stability of two vegetable proteins were studied and compared to β-casein. Proteins used ranged from flexible to rigid/globular in the order of β-casein, gliadin and soy glycinin. Experiments were performed at pH 6.7. Network forming properties were characterised by the surface dilational modulus (determined with the ring trough) and the critical falling film length (L_still) at which a stagnant protein film will break. Gliadin had the highest dilational modulus, followed by glycinin and β-casein, whereas glycinin formed the strongest film against fracture in the overflowing cylinder. The rate of decrease in the surface tension was studied at the air–water (Wilhelmy plate method) and the oil–water interface (bursting membrane) and the dynamic surface tension during compression and expansion in the caterpillar. Gliadin had the lowest equilibrium interfacial tensions and β-casein the lowest dynamic surface tension during expansion. Hardly any foam could be formed at a concentration of 0.1 g/l by shaking. At a concentration of 1.4 g/l most foam was formed by β-casein, followed by gliadin and glycinin. It seems that in the first place the rate of adsorption is important for foam formation. For the vegetable proteins, adsorption was slow. This resulted in lower foamability, especially for glycinin.     

First-principle studies on the electronic structure of Fe3O4(110) surface

The first-principle was employed to study the six possible models for the Fe₃O₄(110) surface, namely the AB-terminated surface (AB model), the AB-terminated with Fe_A vacancy (AB-Fe_A vac model), the AB-terminated with Fe_B vacancy (AB-Fe_B vac model), the B-terminated surface (B model), the B-terminated surface with Fe_B vacancy (B-Fe_B vac model) and the B-terminated surface with O vacancy (B-O vac model). The stability, the electronic structure and the magnetic properties of the six surface models were also calculated. The results predict that the B-O vac model is more stable than other types of surface models. The half-metallic property remain in the AB and B models, while the other four surface models exhibit metallic properties. At the same time, the AB, AB-Fe_A vac, AB-Fe_B vac, B and the B-Fe_B vac models have ferrimagnetic properties, while the B-O vac model has antiferromagnetic property.      

枸橼酸铋制剂中铋元素的溶出量分析

微波消解溶样，ICP—AES法测定了枸橼酸铋制剂中铋元素的含量及其在人工胃液和人工肠液中的溶出量。结果表明，枸橼酸铋制剂中的铋元素在人工肠液中的溶出量明显高于人工胃液。方法的检出限为12ng／mL，相对标准偏差(n=7)为3．84％。     

A high-speed high-sensitivity acoustic cell for in-line continuous monitoring of MOCVD precursor gases

We describe a continuous wave resonant acoustic sensor that has been optimized as a very sensitive in-line monitor for measuring the composition of precursor gases used in MOCVD processes. The precursor/carrier gas mixtures flow through a compact stainless steel acoustic chamber that is isolated from the acoustic transducers by a set of metallic diaphragms. The sensor has been successfully operated at supply line pressures from atmosphere down to 50 Torr with gas flow rates of up to 1600 sccm. The accuracy of the speed of sound measurement for hydrogen gas is better than 0.005%, even in a high noise and low pressure environment. Hydrogen, as well as nitrogen or argon carrier gases, are accommodated within the instrument's 1–5 kHz working frequency range. The instrument's sensitivity and stability are demonstrated with the laboratory data. Measurements of the dynamic response characteristics of the metalorganic bubbler lines at low pressure are also be presented. Application of the cell is general, encompassing any of the metalorganic and hydride materials typically used in MOCVD processes.     

Focusing-defocusing phenomena of radio echo signal after passage of the morning solar terminator

Summary Campaign results of high-repetition ionospheric soundings, performed at the ionospheric station of Rome using a Digisonde 128P, are presented. We introduce an index derived from run rapid ionograms that can be used to detect oscillations of isodensity surfaces ofF ionospheric region started by morning solar terminator.     

Substitution of calcium by strontium within selected calcium phosphates

Sr incorporation in the molecules of amorphous calcium phosphate, apatitic tricalcium phosphate, hydroxyapatite, octacalcium phosphate and dicalcium phosphate dihydrate was investigated. The concentration of Sr ranged from 225 to 1010 μ g / g, i.e. it overlapped with the physiological range of Sr concentrations in human bone. The leading experimental technique was extended X-ray absorption fine structure (EXAFS) at the Sr K edge. Results of these studies demonstrated the following: (1) Sr incorporation in the calcium phosphates is compound-dependent, (2) the coordination of incorporated Sr atoms in the Ca-P molecules is similar to that of Ca atoms, but interatomic distances are ≈0.015 nm larger, (3) in apatitic tricalcium phosphate, hydroxyapatite and octacalcium phosphate lattices Sr atoms may occupy selected Ca sites, which was not the case for dicalcium phosphate dihydrate, (4) in the apatite lattice Sr atoms are coordinated by 6 PO₄ tetrahedrals and (5) EXAFS spectra at the K edge of the incorporated Sr may be used to distinguish the structures of amorphous calcium phosphate, dicalcium phosphate dihydrate as well as apatite and its derivatives (apatitic tricalcium phosphate, octacalcium phosphate).